Checking The Configuration - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
----End

9.9.5 Checking the Configuration

After two-way frame delay measurement is configured on a VPLS network, you can view
statistics of the delay in bidirectional frame transmission.
Prerequisite
The configurations of two-way frame delay measurement on a VPLS link are complete.
Procedure
l
----End
Example
Run the
you can view information about two-way frame delay measurement and frame jitter.
<HUAWEI> display y1731 statistic-type twoway-delay md md1 ma ma1 peer-ip 2.2.2.2
Issue 02 (2011-09-10)
The system view is displayed.
2. Run:
cfm md md-name
The MD view is displayed.
3. Run:
ma ma-name
The MA view is displayed.
4. Run:
delay-measure two-way
id mep-id } interval { 1000 | 10000 } count count-value [ peer-ip peer-ip
[ vc-id vc-id ] ]
On-demand two-way frame delay measurement is enabled on a PW.
The peer-ip peer-ip parameter or the vc-id vc-id parameter does not need to be
configured and CFM must be disabled if on-demand two-way frame delay
measurement is performed on PWs on a PBB VPLS network.
Perform the following steps to verify that CFM is disabled on a PBB VPLS network:
– Run the vsi vsi-name command to enter the I-VSI view.
– Run the display this
exists in the I-VSI view.
– If the command is displayed in the command output, run the
command to disable CFM. If the command does not exists, no action is required.
NOTE
l If the local MEP has not learned the MAC address of the remote MEP, specify the
destination MAC address for the two-way frame delay measurement.
l If the local MEP has learned the MAC address of the remote MEP or the remote MEP has
been bound to the MAC address of the local MEP, specify the remote MEP ID for the two-
way frame delay measurement.
Run the display y1731 statistic-type
ip-address [ count count-value ] command to check Y.1731 performance statistics.
display y1731 statistic-type
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
mep mep-id mep-id { mac mac-address | remote-mep mep-
command to check whether or not the cfm enable command
twoway-delay md md-name ma ma-name peer-ip
command on the device where the MEP is located, and
9 Y.1731 Configuration
undo cfm enable
600