Checking The Configuration - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is enabled globally and the BFD view is displayed.
Step 3 Run:
delay-up
The time the BFD session is delayed to go Up is set.
By default, the delay time is 0 seconds.
----End

5.9.3 Checking the Configuration

By viewing the delay of a BFD session to go Up, you can check whether the configurations are
successful.
Prerequisite
The configurations of the delay of a BFD session to go Up are complete.
Procedure
Step 1 Run the
----End
Example
# After the configuration, restart the router. After the restart, run the
command.
The System Session Delay Up Timer field in the command output. This field displays the status
of the current system delay Up time. OFF indicates that the system is in the normal state; Xs
indicates that after X seconds, the system recovers, and the BFD session goes Up.
<HUAWEI> display bfd statistics
Current Display Board Number : Main ; Current Product Register Type:
IP Multihop Destination Port : 3784
Total Up/Down Session Number : 0/1
Current Session Number :
--------------------------------------------------------------------------------
PAF/LCS Name
--------------------------------------------------------------------------------
BFD_CFG_NUM
BFD_IF_NUM
Issue 02 (2011-09-10)
seconds
display bfd statistics
Static session : 0
E_Dynamic session : 0
LDP_LSP session : 0
TE_TUNNEL session : 0
PW session : 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
[ slot slot-id ] command to check statistics about global BFD.
Dynamic session
STATIC_AUTO session
STATIC_LSP session
TE_LSP session
IP session
Maxnum
8192
512
5 BFD Configuration
display bfd statistics
: 0
: 1
: 0
: 0
: 1
Minnum Create
1 1
1 1
265