Huawei NetEngine80E Configuration Manual - Reliability page 530

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
8.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Configure the interface mode on each PE to the user termination mode.
# Configure PE1.
<HUAWEI> system-view
[HUAWEI] sysname PE1
[PE1] interface gigabitethernet 2/0/0
[PE1-GigabitEthernet2/0/0] mode user-termination
[PE1-GigabitEthernet2/0/0] undo shutdown
[PE1-GigabitEthernet2/0/0] quit
# Configure PE2.
<HUAWEI> system-view
[HUAWEI] sysname PE2
[PE2] interface gigabitethernet 2/0/0
[PE2-GigabitEthernet2/0/0] mode user-termination
[PE2-GigabitEthernet2/0/0] undo shutdown
[PE2-GigabitEthernet2/0/0] quit
Step 2 Enable an IGP on the MPLS backbone network. OSPF is adopted in this example.
Assign an IP address to each interface on each PE and the P router as shown in
After OSPF is enabled, the 32-bit loopback addresses of PE1, P, and PE2 must be advertised.
Issue 02 (2011-09-10)
Configure the interface mode on PE1 and PE2 to the user termination mode.
Run an IGP to ensure connectivity of routers on the backbone network
Enable MPLS on the backbone network and set up an LSP tunnel.
Set up the remote MPLS LDP peer relationship between PEs on both ends of the PW.
Configure a sub-interface for QinQ VLAN tag termination on the AC interface of each PE
Create an MPLS L2VC on each PE and bind each sub-interface for QinQ VLAN tag
termination to the L2VC interface.
Configure VLL-based Ethernet CFM on each PE.
Enable Layer 2 forwarding and QinQ on each switch.
Interface name of each PE connected to each CE
IP address of each interface
L2VC IDs on both ends of the PW (They must be the same.)
MPLS LSR ID of each PE and the P router
IP address of the remote peer of each PE
Tag value that is terminated on the sub-interface for QinQ VLAN tag termination
Name and level of each MD, name of each MA, MEP ID, name of the interface on which
the MEP resides, and type of the MEP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
Figure 8-24.
513