Example For Configuring Vrrp6 Backup Groups In Load Balancing Mode - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
4.14.12 Example for Configuring VRRP6 Backup Groups in Load
Balancing Mode
Network Requirements
As shown in
l
l
l
Figure 4-16 Networking diagram of VRRP6 backup groups in load balancing mode
2000::3/64
2000::4/64
Issue 02 (2011-09-10)
interface Pos2/0/0
link-protocol ppp
undo shutdown
ipv6 enable
ipv6 address 2001::2/64
ospfv3 1 area 0.0.0.0
#
return
NOTE
POS interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
Figure 4-16,
Router A is the master router in backup group 1 and the backup router in backup group 2.
Router B is the master router in backup group 2 and the backup router in backup group 1.
Host A of a LAN uses the virtual IPv6 address of backup group 1 as a default gateway
address and Host B uses that of backup group 2. This can implement data flow load
balancing and mutual backup between these two backup groups.
Backup group 1
Virtual IP Address
2000::100
HostA
HostB
Etherent
Backup group 2
Virtual IP Address
2000::60
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RouterA
group 1:Master
group 2:Backup
POS1/0/0
2002::1/64
GE1/0/0
2000::1/64
RouterC
POS1/0/0
GE1/0/0
2001::1/64
2000::2/64
RouterA
group 1:Backup
group 2:Master
4 VRRP Configuration
POS1/0/0
2002::2/64
Eth3/0/0
2003::2
HostC
POS2/0/0
2003::1/64
2001::2/64
227