Example For Configuring Vpls Ethernet Cfm - Huawei NetEngine80E Configuration Manual - Reliability

Hide thumbs Also See for NetEngine80E:

Table of Contents

HUAWEI NetEngine80E/40E Router

Configuration Guide - Reliability

8.18.7 Example for Configuring VPLS Ethernet CFM

In this example, by configuring VPLS Ethernet CFM, you can detect connectivity faults between

Networking Requirements

signaling to create Pseudo Wires (PWs). Configure VPLS Ethernet CFM on PEs to fast detect

VPLS connectivity between PEs.

Figure 8-22 Diagram of configuring VPLS Ethernet CFM

Configuration Roadmap

The configuration roadmap is as follows:

Issue 02 (2011-09-10)

8-22, Martini VPLS runs on the backbone network and LDP is used as

100.2.1.2/30

100.2.1.1/30

100.1.1.1/30

Run the Interior Gateway Protocol (IGP) on the backbone network. routers across the

backbone network then can communicate.

Configure the routing protocols on the backbone network to enable communication

between routers and basic functions of MPLS.

Set up LSP tunnels between PEs.

Enable MPLS L2VPN on PEs.

Create Virtual Switch Instances (VSIs) on PEs and bind VSIs to Attachment Circuit (AC)

Huawei Proprietary and Confidential

100.3.1.2/30

100.1.1.2/30

8 Ethernet OAM Configuration

100.3.1.1/30

Netengine40e