Configuring Basic Ethernet Cfm; Establishing The Configuration Task - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Prerequisite
The configurations of Associating EFM OAM with an Interface function are complete.
Procedure
Step 1 Run the
EFM OAM configuration information on an interface.
----End
Example
Run the
that the configuration succeeds.
<HUAWEI> display efm interface gigabitethernet 1/0/1
Item
----------------------------------------------------
Interface:
EFM Enable Flag:
Mode:
OAMPDU MaxSize:
OAMPDU Timeout:
ErrCodeNotification:
ErrCodePeriod:
ErrCodeThreshold:
ErrFrameNotification:
ErrFramePeriod:
ErrFrameThreshold:
ErrFrameSecondNotification:
ErrFrameSecondPeriod:
ErrFrameSecondThreshold:
Hold Up Time:
ThresholdEvtTriggerErrDown:
TriggerIfDown:
TriggerMacRenew:
Remote MAC:
Remote EFM Enable Flag:
Remote Mode:
Remote MaxSize:
Remote State:

8.6 Configuring Basic Ethernet CFM

By configuring basic Ethernet CFM functions, you can implement end-to-end detection,
advertisement, verification, and location of connectivity faults.

8.6.1 Establishing the Configuration Task

Before configuring basic Ethernet CFM functions, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
CFM is mainly used to monitor the connectivity of end-to-end links or direct links.
Issue 02 (2011-09-10)
display efm { all | interface interface-type interface-number } command to check the
display efm command. If the item "TriggerIfDown" is displayed as "enable", it means
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
GigabitEthernet1/0/1
enable
active
128
3000
disable
1
1
disable
1
1
disable
60
1
0
enable
enable
disable
0018-8200-0001
enable
passive
128
--
8 Ethernet OAM Configuration
405