Huawei NetEngine80E Configuration Manual - Reliability page 685

Hide thumbs Also See for NetEngine80E:
Table of Contents

Advertisement

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
In real world situations, CC and CV are usually used together. Therefore, these two functions
are integrated on the NE80E/40E. Perform the following steps on the MEP and RMEP:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls-tp meg
A MEG is created and the MEG view is displayed.
Step 3 (Optional) Run the following command as needed:
Ensure that the same CCM transmission interval is set on the MEP and RMEP; otherwise, an alarm will be
generated.
l To configure the interval between CCM transmissions, run:
l To configure the priority of CCMs, run:
Step 4 Perform the following steps to enable CC and CV on the MEP and RMEP. This can prevent
MEPs from generating alarms mistakenly during enabling process.
1.
2.
3.
Issue 02 (2011-09-10)
meg-name
NOTE
cc interval
interval-value
CCM transmission intervals and their application scenarios are as follows:
– 3.3 ms: 300 frames are sent per second. This interval is recommended in protection
switching.
– 10 ms: 100 frames are sent per second.
– 100 ms: 10 frames are sent per second. This interval is recommended in performance
monitoring.
– 1000 ms: 1 frame is sent per second. This interval is recommended in fault management.
– 10000 ms: 6 frames are sent per minute.
– 60000 ms: 1 frame is sent per minute.
– 600000 ms: 6 frames are sent per hour.
Select a proper CCM transmission interval to suit the CC application requirement.
cc exp
exp-value
If the MPLS-TP network is severely congested and the priority of CCMs is low, CCMs cannot
be sent. Therefore, a proper priority needs to be configured for CCMs based on network
conditions.
On the MEP, run:
cc send enable
Sending CC/CV packets is enabled on the MEP.
On the RMEP, run:
cc send enable
Sending CC/CV packets is enabled on the RMEP.
On the MEP, run:
cc receive enable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 MPLS-TP OAM Configuration
668

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netengine40e

Table of Contents