Huawei NetEngine80E Configuration Manual - Reliability page 723

Hide thumbs Also See for NetEngine80E:

Table of Contents

HUAWEI NetEngine80E/40E Router

Configuration Guide - Reliability

Figure 10-10 Networking diagram for a PW built over a bidirectional LSP

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Step 1 Set up a PW over a bidirectional LSP.

For details about how to set up a PW (between LSRs) based on a bidirectional LSP, see see

"Configuring a PW" in the <HUAWEI NetEngine80E/40E Router Configuration Guide-MPLS

or information in the configuration files of this configuration example.

Step 2 Create an ME and bind it to a PW.

# Create an ME named test on PE1 and bind the ME to the PW.

<HUAWEI> system-view

[HUAWEI] sysname PE1

[PE1] mpls-tp meg test

[PE1-mpls-tp-meg-test] me l2vc peer-ip 3.3.3.3 vc-id 30000 vc-type vlan mep-id 1

remote-mep-id 2

# Create an ME named test on PE3 and bind the ME to the PW.

<HUAWEI> system-view

[HUAWEI] sysname PE3

[PE3] mpls-tp meg test

[PE3-mpls-tp-meg-test] me l2vc peer-ip 1.1.1.1 vc-id 30000 vc-type vlan mep-id 2

remote-mep-id 1

Issue 02 (2011-09-10)

that packet forwarding is based on label switching only. Therefore, the correctness of label-

based forwarding must be guaranteed.

Create an ME and bind it to a PW.

Configure the interval between CCM transmissions and priority of CCMs.

Enable CC and CV.

ID of the VC bound to the ME

Interval between CCM transmissions and priority of CCMs

Huawei Proprietary and Confidential

10 MPLS-TP OAM Configuration

Netengine40e