Switching Ieee 802.1Ag Versions; Enabling Ethernet Cfm Globally - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
No.
3
4
5
6
7
8

8.6.2 Switching IEEE 802.1ag Versions

A device can switch its Ethernet CFM version between IEEE 802.1ag Draft 7 and IEEE Standard
802.1ag-2007.
Context
By default, IEEE 802.1ag Draft 7 is enabled on the device. Do as follows on each NE80E/40E
that requires IEEE Standard 802.1ag-2007:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm version
The IEEE 802.1ag version is switched.
----End

8.6.3 Enabling Ethernet CFM Globally

You must enable Ethernet CFM globally before configuring and applying all CFM functions.
Context
Do as follows on the router that requires Ethernet CFM:
Issue 02 (2011-09-10)
Data
Name of an MA, ID of the VLAN associated with the MA
ID of a MEP, name of the interface on which the MEP resides, type of the MEP
(Optional) ID of an RMEP and MAC address of the interface where the RMEP resides
Rule for creating a MIP
Interval for a MEP sending or detecting CCMs in an MA
(Optional) ID of the specified VLAN
{ draft7 | standard }
NOTE
All the devices on the network must be enabled with either IEEE 802.1ag Draft 7 or IEEE Standard
802.1ag-2007. IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007 cannot be enabled at the same time
on a network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
407