Checking The Configuration - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
interface
The active interface view is displayed.
Step 3 Run:
standby bandwidth
The maximum bandwidth of the active interface is configured.
By default, on the active interface, its actual physical bandwidth is adopted as its maximum
available bandwidth.
Step 4 Run:
standby timer flow-check
The flow check interval for the active interface is configured.
By default, the flow check interval is set to 30 seconds.
----End

2.3.5 Checking the Configuration

By viewing the status of the active and standby interfaces or traffic statistics, you can check
whether the configurations are successful.
Prerequisite
The configurations of the load balancing interface backup function are complete.
Procedure
l
l
----End
Example
After the configuration, you can run the
statistics of the active interface working in load-balancing mode.
<HUAWEI> display standby state
Interface
GigabitEthernet 2/0/0
GigabitEthernet 1/0/0
GigabitEthernet 1/0/0
Backup-flag meaning:
M---MAIN
D---LOAD
After the configuration, you can run the
the active and standby interfaces.
<HUAWEI> display standby flow
Interfacename
Flow-interval(s)
LastInOctets
LastOutOctets
Issue 02 (2011-09-10)
interface-type interface-number
size
Run the display standby flow
working in load-balancing mode.
Run the display standby state
interfaces.
Interfacestate Backupstate Backupflag Pri Loadstate
B---BACKUP
P---PULLED
: GigabitEthernet 2/0/0
: 30
: 5298
: 398807420
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
time
command to check the flow statistics of the active interface
command to check the status of the active and standby
display standby flow
UP
UP
STANDBY
V---MOVED U---USED
G---LOGICCHANNEL
display standby state
2 Interface Backup Configuration
command to check the flow
MUP MUD
UP BU
STANDBY BU
command to check the status of
40
20
22