Binding An Ma To A Vll - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Figure 9-5 Networking diagram for performance monitoring
This section describes how to configure single-ended frame loss measurement on an AC and a
PW in VLL networking.
Pre-configuration Tasks
Before configuring single-ended frame loss measurement on a VLL, complete the following
tasks:
l
Data Preparation
To configure single-ended frame loss measurement on a VLL, you need the following data.
No.
1
2
3
4

9.2.2 Binding an MA to a VLL

Binding an MA to a VLL is a prerequisite for configuring single-ended frame loss measurement,
dual-ended frame loss measurement,one-way frame delay measurement, or two-way frame delay
measurement on the VLL.
Issue 02 (2011-09-10)
Services Access
DSLAM
Y.1731
Configuring single-ended frame loss measurement on an PW
– Completing VLL-related configurations on PEs
For details, see the chapter "VLL Configuration" in the NE80E/40E Configuration
Guide - VPN.
– Completing CFM-related configurations and configuring the MEP type as inward
Data
Names of an MD and an MA
ID and type of a MEP and name of the interface where the MEP is located
VC ID of the VLL bound to an MA
Interval for sending packets and the number of sent packets
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Metro
PE1 P
Y.1731
9 Y.1731 Configuration
PE2
BRAS
Core
Y.1731
MEP
MIP
559