Binding The Service Vrrp Backup Group To The Mvrrp Backup Group - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Pre-configuration Tasks
Before configuring VRRP fast switchover using BFD sampling, complete the following tasks:
l
l
l
Data Preparation
To configure VRRP fast switchover using BFD sampling, you need the following data.
No.
1
2
3
4.5.2 Binding the Service VRRP Backup Group to the mVRRP
Backup Group
Through the bindings between member VRRP backup groups and the mVRRP backup group,
the state machines of member VRRP backup groups can be consistent with the state machine of
the mVRRP backup group.
Context
Do as follows on the device that need perform VRRP fast switchover:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface
The view of the interface where the service VRRP backup group is configured is displayed.
Step 3 Run:
vrrp vrid
number vrid virtual-router-id2
The service VRRP backup group is bound to the mVRRP backup group.
After the binding, the state machine of the service VRRP backup group becomes dependent.
That is, the service VRRP backup group deletes the protocol timer and stops sending or receiving
Issue 02 (2011-09-10)
Configuring network layer attributes for interfaces to ensure network connectivity
Configuring VRRP backup groups, including service VRRP backup groups and mVRRP
backup groups
Configuring BFD sessions, including link BFD sessions and peer BFD sessions (It is
required to configure BFD sessions between the PE and each CE.)
Data
Virtual Router IDs (VRIDs) and virtual IP addresses
Priorities of VRRP backup groups
Local and remote discriminators of BFD sessions
interface-type interface-number[.subinterface-number ]
virtual-router-id1 track admin-vrrp interface interface-type interface-
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
99