Checking The Configuration; Testing The Packet Loss Ratio On The Physical Link - Huawei Quidway S6700 series Configuration Manual

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
l
l

4.4.6 Checking the Configuration

By viewing EFM OAM configurations, you can check whether the configurations are successful.
Prerequisite
The configurations of the EFM OAM link monitoring function are complete.
Procedure
l
l
----End
Example
Run the display efm command. You can view information about link monitoring on the
interface. For example:
<Quidway> display efm interface xgigabitethernet 0/0/1

4.5 Testing the Packet Loss Ratio on the Physical Link

By testing the packet loss ratio on a physical link, you can take effective measures to ensure
better performance of the link.
Issue 01 (2011-07-15)
Run the efm holdup-timer command in the interface view to configure the interface to go
administratively Up after the auto-recovery delay.
Run the shutdown command and then the undo shutdown command in the interface view
to restore the administrative state of the interface to Up.
Run the display efm { all | interface interface-type interface-number } command to check
information about EFM OAM on an interface.
Run the display efm session { all | interface interface-type interface-number } command
to check the status of the EFM OAM protocol on an interface.
Item
----------------------------------------------------------
Interface:
EFM Enable Flag:
Mode:
OAMPDU MaxSize:
ErrCodeNotification:
ErrCodePeriod:
ErrCodeThreshold:
ErrFrameNotification:
ErrFramePeriod:
ErrFrameThreshold:
ErrFrameSecondNotification:
ErrFrameSecondPeriod:
ErrFrameSecondThreshold:
Hold Up Time:
ThresholdEvtTriggerErrDown:
TriggerIfDown:
TriggerMacRenew:
RemoteMAC
Remote EFM Enable Flag
Remote Mode
Remote MaxSize
Remote State:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration-EFM
Value
XGigabitEthernet0/0/1
enable
active
128
enable
1
1
enable
1
1
enable
60
1
0
enable
disable
disable
00e0-fc7f-7258
enable
passive
128
--
160