Configuration Command Modes - Edge-Core Direk Tronik 24/48-Port Management Manual

31
Using the Command Line Interface
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
Mode Command
Line line {console | vty}
Access access-list ip standard
Control List access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Class Map class-map
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)#
MSTP spanning-tree mst-configuration
Policy Map policy-map
VLAN vlan database
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
. .
.
Console(config-if)#exit
Console(config)#
31-8
Table 31-2 Configuration Command Modes
Prompt
Console(config-line)#
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-cmap)
Console(config-mstp)#
Console(config-pmap)
Console(config-vlan)
Page
36-1
44-2
44-2
44-12
44-7
44-7
56-2
45-1
51-7
56-4
52-5