Edge-Core ECS4810-12M Layer 2 Management Manual page 177

To add member ports to a static trunk:
Click Interface, Trunk, Static.
1.
Select Configure Trunk from the Step list.
2.
Select Add Member from the Action list.
3.
Select a trunk identifier.
4.
Set the unit and port for an additional trunk member.
5.
Click Apply.
6.
Figure 46: Adding Static Trunks Members
To configure connection parameters for a static trunk:
Click Interface, Trunk, Static.
1.
Select Configure General from the Step list.
2.
Select Configure from the Action list.
3.
Modify the required interface settings. (Refer to
4.
List" on page 150 for a description of the parameters.)
Click Apply.
5.
Figure 47: Configuring Connection Parameters for a Static Trunk
– 177 –
| Interface Configuration
C 5
HAPTER
Trunk Configuration
"Configuring by Port