Table 28: Configuration Command Modes - Edge-Core ECS4610-24F Management Manual

| Using the Command Line Interface
C 22
HAPTER
Entering Commands
VLAN Configuration - Includes the command to create VLAN groups.
◆
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
"Console(config)#" which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.

Table 28: Configuration Command Modes

Mode Command
Access access-list ip standard
Control List
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Class Map class-map
DHCP ip dhcp pool
Line line {console | vty}
Interface interface {ethernet port |
port-channel id| vlan id}
MSTP spanning-tree mst-configuration
Policy Map policy-map
Router router {pim | rip | ospf}
Time Range time-range
VLAN vlan database
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
– 574 –
Prompt
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-cmap)
Console(config-dhcp)
Console(config-line)
Console(config-if)
Console(config-mstp)
Console(config-pmap)
Console(config-router)
Console(config-time-range)
Console(config-vlan)
Page
748
748
760
755
756
886
983
600
770
813
889
1091
1025
1043
625
837