Configuring A Dynamic Trunk - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Interface Configuration

Trunk Configuration

ONFIGURING A

To display trunk connection parameters:

Click Interface, Trunk, Static.

Select Configure General from the Step list.

Select Show Information from the Action list.

Figure 48: Showing Information for Static Trunks

Use the Interface > Trunk > Dynamic (Configure Aggregator) pages to set

the administrative key for an aggregation group, enable LACP on a port,

and configure protocol parameters for local and partner ports, or to set

Ethernet connection parameters.

Figure 49: Configuring Dynamic Trunks

"Link Aggregation Commands" on page 979

To avoid creating a loop in the network, be sure you enable LACP before

connecting the ports, and also disconnect the ports before disabling

If the target switch has also enabled LACP on the connected ports, the

trunk will be activated automatically.

A trunk formed with another switch using LACP will automatically be

assigned the next available trunk ID.

If more than eight ports attached to the same target switch have LACP

enabled, the additional ports will be placed in standby mode, and will

only be enabled if one of the active links fails.

Chapters

Table of Contents