Mapping Protocol Groups To Interfaces - Edge-Core ECS4810-12M Layer 2 Management Manual

Figure 84: Configuring Protocol VLANs
To configure a protocol group:
1.
2.
3.
Figure 85: Displaying Protocol VLANs
Use the VLAN > Protocol (Configure Interface - Add) page to map a
M
APPING
protocol group to a VLAN for each interface that will participate in the
P G
ROTOCOL ROUPS
group.
I
TO NTERFACES
CLI R
◆
C
◆
Click VLAN, Protocol.
Select Configure Protocol from the Step list.
Select Show from the Action list.
EFERENCES
"protocol-vlan protocol-group (Configuring Interfaces)" on page 1129
U
OMMAND SAGE
When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. If you assign interfaces using any of the other
VLAN menus such as the VLAN Static table
will admit traffic of any protocol type into the associated VLAN.
– 223 –
| VLAN Configuration
C 6
HAPTER
Protocol VLANs
(page 204), these interfaces