Adding An Interface To A Qinq Tunnel - Edge-Core ECS4810-12M Layer 2 Management Manual

| VLAN Configuration
C 6
HAPTER
IEEE 802.1Q Tunneling
A I
DDING AN NTERFACE
Q Q T
TO A IN UNNEL
Follow the guidelines in the preceding section to set up a QinQ tunnel on
the switch. Then use the VLAN > Tunnel (Configure Interface) page to set
the tunnel mode for any participating interface.
CLI R
EFERENCES
"Configuring IEEE 802.1Q Tunneling" on page 1114
◆
C U
OMMAND SAGE
Use the Configure Global page to set the switch to QinQ mode before
◆
configuring a tunnel access port or tunnel uplink port (see
QinQ Tunneling on the Switch" on page
Identifier (TPID) value of the tunnel access port if the attached client is
using a nonstandard 2-byte ethertype to identify 802.1Q tagged
frames.
Then use the Configure Interface page to set the access interface on
◆
the edge switch to Access mode, and set the uplink interface on the
switch attached to the service provider network to Uplink mode.
P
ARAMETERS
These parameters are displayed:
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-12)
◆
Trunk – Trunk Identifier. (Range: 1-12)
◆
Mode – Sets the VLAN membership mode of the port.
◆
None – The port operates in its normal VLAN mode. (This is the
■
default.)
Access – Configures QinQ tunneling for a client access port to
■
segregate and preserve customer VLAN IDs for traffic crossing the
service provider network.
Uplink – Configures QinQ tunneling for an uplink port to another
■
device within the service provider network.
W I
EB NTERFACE
To add an interface to a QinQ tunnel:
Click VLAN, Tunnel.
1.
Select Configure Interface from the Step list.
2.
Set the mode for any tunnel access port to Access and the tunnel uplink
3.
port to Uplink.
Click Apply.
4.
– 220 –
"Enabling
217). Also set the Tag Protocol