CLI Commands: Base
4.3.13 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent
across a network to an SNMP Network Manager. These messages alert the
manager to events occurring within the switch or on the network. Six trap re-
ceivers are simultaneously supported.
Format
show snmptrap
Mode
Privileged EXEC and User EXEC
SNMP Trap Name
The community string of the SNMP trap packet sent to the trap man-
ager. This may be up to 16 alphanumeric characters. This string is
case sensitive.
IP Address
The IP address to receive SNMP traps from this device. Enter four
numbers between 0 and 255 separated by periods.
Status
A pull down menu that indicates the receiver's status (enabled or dis-
abled) and allows the administrator/user to perform actions on this
user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
74
4.3 Management Commands
CLI L2B
Release 4.0 11/07