Arp Retries; Arp Timeout; Show Arp - Hirschmann PowerMICE Reference Manual

4.1.7 arp retries

This command configures the ARP count of maximum request for retries.
The value for
The range for
Default
Format
Mode
4.1.7.1 no arp retries
This command configures the default ARP count of maximum request for retries.
Format
Mode

4.1.8 arp timeout

This command configures the ARP entry ageout time.
The value for
seconds. The range for
Default
Format
Mode
4.1.8.1 no arp timeout
This command configures the default ARP entry ageout time.
Format
Mode
4.1.9 clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the
gateway parameter is specified, the dynamic entries of type gateway are purged as well.
Format
Mode

4.1.10 show arp

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are not the
total ARP entries. To view the total ARP entries, the operator should view the
conjunction with the
Format
Mode
Routing Commands
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
is an integer, which represents the maximum number of request for retries.
<retries>
is an integer between 0-10 retries.
<retries>
4
arp retries <0-10>
Global Config
no arp retries
Global Config
is a valid positive integer, which represents the IP ARP entry ageout time in
<seconds>
is between 15-21600 seconds.
<seconds>
1200
arp timeout <15-21600>
Global Config
no arp timeout
Global Config
clear arp-cache [gateway]
Privileged EXEC
show arp switch
show arp
Privileged EXEC
results.
results in
show arp
19