Classofservice Trust - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.2.3 classofservice trust

This command sets the class of service trust mode of an interface. The mode
can be set to trust one of the Dot1p (802.1p) or IP DSCP packet markings.
Note: In trust ip-dscp mode the switch modifies the vlan priority for out-
going frames according to
– the DSCP mapping and VLAN mapping table (Power MICE, MACH 4000)
– the a fix mapping table
(see Reference Manual „Web-based Management for further details").
Format
classofservice trust dot1p | <ip-dscp>
Mode
Global Config or
Interface Config (Power MICE, MACH 4000)
no classofservice trust
U
This command sets the interface mode to untrusted, i.e. the packet prior-
ity marking is ignored and the default port priority is used instead.
Format
no classofservice trust
Modes
Global Config or
Interface Config (Power MICE, MACH 4000)
CLI L2B
Release 4.0 11/07
4.2 Class of Service (CoS) Commands
59