Classofservice Dot1P-Mapping - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.2.1 classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class for a device
when in 'Global Config' mode. The number of available traffic classes may
vary with the platform. Userpriority and trafficclass can both be the range
from 0-7. The command is only available on platforms that support priority to
traffic class mapping on a 'per-port' basis, and the number of available traffic
classes may vary with the platform.
Format
classofservice dot1p-mapping <userpriority> <traf
ficclass>
Mode
Global Config or Interface Config
no classofservice dot1p-mapping
U
This command restores the default mapping of the 802.1p priority to an
internal traffic class.
Format
no classofservice dot1p-mapping
Modes
Global Config or Interface Config
CLI L2B
Release 4.0 11/07
4.2 Class of Service (CoS) Commands
57