Display Elements; Device State - Hirschmann EAGLE20 User Manual

1.7

Display elements

After the supply voltage is set up, the Software starts and initializes the
device. Afterwards, the device performs a self-test. During this process,
various LEDs light up.
1.7.1

Device state

These LEDs provide information about conditions which affect the operation
of the whole device.
ACA
Power
LED Display
Power Supply voltage
Status Device Status
RM Ring Manager
ACA Storage medium
ACA31
ACA22
Installation EAGLE20/30
Release 12 03/2021
RM
Status
Color Activity
— none
yellow lights up
flashes 4 times
a period
green lights up
— none
green lights up
red lights up
flashes 1 time
a period
— none
— none
green lights up
flashes 3 times
a period
yellow lights up
Meaning
Supply voltage is too low
Device variants with redundant power
supply:
Supply voltage 1 or 2 is on
Software update is running. Maintain the
power supply.
Device variants with redundant power
supply:
Supply voltage 1 and 2 is on
Device variants with single power supply:
Supply voltage is on
Device starts
Device is not ready for operation
Device is ready for operation.
Characteristics can be configured
The device reports a detected error.
See "Reference Manual GUI Graphical
User Interface", Chapter "Device Status".
The boot parameters used when the device
has been started differ from the boot
parameters saved.
Start the device again.
The support of the function is dependent on
the software release. Software support for
the function is unimplemented at the time of
publishing this manual.
No ACA connected
ACA storage medium connected
Device writes to/reads from the storage
medium
ACA storage medium inoperative
Check the file system format
interface" on page 30.
Deactivate the write protection on the
ACA31 by pushing the lock towards the
contacts.
See "SD card
27