Ethernet Ports; 10/100/1000 Mbit/S Twisted Pair Port; 100 Mbit/S F/O Port - Hirschmann MACH104-16TX-PoEP+2X Series User Manual

1.6

Ethernet ports

You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
1.6.1

10/100/1000 Mbit/s twisted pair port

This port is an RJ45 socket.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
This port supports:
 Autonegotiation
 Autopolarity
 Autocrossing (if autonegotiation is activated)
 1000 Mbit/s full duplex

100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode

10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Note: Some of these ports also support Power over Ethernet (PoE).
See "PoE ports" on page 20.
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
Figure
Table 7: Pin assignment of a 1000 MBit/s TP interface in MDI-X mode, RJ45
socket - for PoE with the power supplied via the wire pairs transmitting the
signal
1.6.2

100 Mbit/s F/O port

This port is an SFP slot.
The 1000 Mbit/s F/O port offers you the ability to connect network
components according to the IEEE 802.3 100BASE-SX/1000BASE-LX
standard.
Installation MACH104-PoEP
Release 08 01/2019
Pin Function Ports with PoE support:
1 BI_DB+
1
2 BI_DB−
2
3
3 BI_DA+
4
4 BI_DD+
5
6
5 BI_DD−
7
6 BI_DA−
8
7 BI_DC+
8 BI_DC−
PoE voltage feed
Minus terminal of the supply voltage
Minus terminal of the supply voltage
Plus terminal of the supply voltage
Plus terminal of the supply voltage
19