Ethernet Ports; 10/100 Mbit/S Twisted Pair Port; 100/1000 Mbit/S F/O Port (Optional); 100/1000 Mbit/S Twisted Pair Port (Optional) - Hirschmann EAGLE20 User Manual

1.5

Ethernet ports

You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
You find information on pin assignments for making patch cables here:
See "10/100 Mbit/s twisted pair port" on page 25.
1.5.1

10/100 Mbit/s twisted pair port

This port is an RJ45 socket.
The 10/100 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:
 Autonegotiation
 Autopolarity
 Autocrossing (if autonegotiation is activated)

100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode

10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
Table 6: Pin assignment of the 10/100/1000 Mbit/s twisted pair port, RJ45 socket,
10/100 Mbit/s mode
1.5.2

100/1000 Mbit/s F/O port (optional)

This port is an SFP slot.
The 100/1000 Mbit/s F/O port allows you to connect network components
according to the IEEE 802.3 100BASE-FX/1000BASE-SX/1000BASE-LX
standard.
This port supports:

Full duplex mode
1.5.3

100/1000 Mbit/s twisted pair port (optional)

Note: The following information applies only to device variants with
HiSecOS, software versions 01.2.00 and higher.
Installation EAGLE20/30
Release 12 03/2021
Pin
1
1
2
2
3
3
4
6
5
4,5,7,8
6
7
8
Function
RD+ Receive path
RD− Receive path
TD+ Transmission path
TD− Transmission path
—
25