Set Igmp Groupmembershipinterval - Hirschmann RS20 Reference Manual

4.5.13 set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the sys-
tem. The Group Membership Interval time is the amount of time in seconds
that a switch will wait for a report from a particular group on a particular inter-
face before deleting the interface from the entry. This value must be greater
than the IGMP Maximum Response time value. The range is 2 to
3600 seconds.
Default
260
Format
set igmp groupmembershipinterval <2-3600>
Mode
Global Config
no set igmp groupmembershipinterval
U
This command sets the IGMP Group Membership Interval time on the
system to 260 seconds.
Format
no set igmp groupmembershipinterval
Mode
Global Config
CLI L2B
Release 4.0 11/07
4.5 Device Configuration Commands
109