Snmptrap Ipaddr; Snmptrap Mode - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.3.33 snmptrap ipaddr

This command assigns an IP address to a specified community name. The
maximum length of name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table
Format
snmptrap ipaddr <
Mode
Global Config

4.3.34 snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receiv-
ers are active (able to receive traps). Disabled trap receivers are inactive (not
able to receive traps).
Format
snmptrap mode <
Mode
Global Config
no snmptrap mode
U
This command deactivates an SNMP trap. Disabled trap receivers are
inactive (not able to receive traps).
Format
no snmptrap mode <
Mode
Global Config
CLI L2B
Release 4.0 11/07
must be unique. If you make multiple entries
using the same IP address, the first entry is
retained and processed. All duplicate entries are
ignored.
name> <ipaddrold
name> <ipaddr>
name> <ipaddr>
4.3 Management Commands
> <
ipaddrnew>
91