Configuring The Rpf Route Selection Rule; Configuring Multicast Load Splitting; Configuring A Multicast Forwarding Boundary - HP MSR2003 Configuration Manual

Step
3. (Optional.) Delete static
multicast routes.

Configuring the RPF route selection rule

You can configure the router to select the RPF route based on the longest prefix match principle. For more
information about RPF route selection, see
To configure a multicast routing policy:
Step
1. Enter system view.
2. Enter MRIB view.
3. Configure the device to
select the RPF route based
on the longest prefix match.

Configuring multicast load splitting

To optimize the traffic delivery for multiple data flows, you can configure load splitting on a per-source
basis or on a per-source-and-group basis.
To configure multicast load splitting:
Step
1. Enter system view.
2. Enter MRIB view.
3. Configure multicast load
splitting.

Configuring a multicast forwarding boundary

A multicast forwarding boundary sets the boundary condition for the multicast groups in a specific range.
The multicast data for a multicast group travels within a definite boundary in a network. If the destination
address of a multicast packet matches the boundary condition, the packet is not forwarded. If an
interface is configured as a multicast boundary, it can no longer forward multicast packets (including
packets sent from the local device), nor receive multicast packets.
Command
•
Delete a specific static multicast
route:
undo ip rpf-route-static
[ vpn-instance vpn-instance-name ]
source-address { mask-length |
mask } { rpf-nbr-address |
interface-type interface-number }
•
Delete all static multicast routes:
delete ip rpf-route-static
[ vpn-instance vpn-instance-name ]
"RPF check process."
Command
system-view
multicast routing [ vpn-instance
vpn-instance-name ]
longest-match
Command
system-view
multicast routing [ vpn-instance
vpn-instance-name ]
load-splitting { source |
source-group }
46
Remarks
N/A
Remarks
N/A
N/A
By default, the route with the
highest priority is selected as the
RPF route.
Remarks
N/A
N/A
By default, load splitting is
disabled.