Digisol DG-GS4826S Management Manual page 568

C 21 | Unicast Routing
HAPTER
Configuring the Open Shortest Path First Protocol (Version 2)
A NSSA
DDING AN OR
S
TUB
Use the Routing Protocol > OSPF > Area (Configure Area – Add Area) page
to add a not-so-stubby area (NSSA) or a stubby area (Stub).
CLI R
EFERENCES
"router ospf" on page 1192
u
"area stub" on page 1205
u
"area nssa" on page 1203
u
C U
OMMAND SAGE
This router supports up to 5 stubs or NSSAs.
u
P
ARAMETERS
These parameters are displayed in the web interface:
Process ID – Protocol identifier as configured on the Routing
u
Protocol > OSPF > Network Area (Add) page. (Range: 1-65535)
Area ID – Identifier for a not-so-stubby area (NSSA) or stub. The area
u
ID can be in the form of an IPv4 address, or as a four octet unsigned
integer ranging from 0-4294967295.
Set the area ID to the same value for all routers on a network segment
using the network mask to add one or more interfaces to an area.
Area Type – Specifies an NSSA or stub.
u
W I
EB NTERFACE
To add an NSSA or stub to the OSPF administrative domain:
1. Click Routing Protocol, OSPF, Area.
2. Select Configure Area from the Step list.
3. Select Add Area from the Action list.
4. Select a Process ID, enter the area identifier, and set the area type to
NSSA or Stub.
5. Click Apply
Figure 360: Adding an NSSA or Stub
– 568 –