Digisol DG-GS4826S Management Manual page 837

E
XAMPLE
Console(config)#access-list mac jerry
Console(config-mac-acl)#
R
ELATED
permit, deny (837)
mac access-group (839)
show mac access-list (840)
permit, deny
This command adds a rule to a MAC ACL. The rule filters packets matching
a specified MAC source or destination address (i.e., physical layer address),
(MAC ACL)
or Ethernet protocol type. Use the no form to remove a rule.
S
YNTAX
{permit | deny}
no {permit | deny}
The default is for Ethernet II packets.
N :
OTE
{permit | deny} tagged-eth2
no {permit | deny} tagged-eth2
{permit | deny} untagged-eth2
no {permit | deny} untagged-eth2
C
OMMANDS
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype protocol [protocol-bitmask]]
– 837 –
C 31 | Access Control Lists
HAPTER
MAC ACLs