Digisol DG-GS4826S Management Manual page 345

C U
OMMAND SAGE
A secure port has the following restrictions:
u
It cannot be used as a member of a static or dynamic trunk.
n
It should not be connected to a network interconnection device.
n
The default maximum number of MAC addresses allowed on a secure
u
port is zero. You must configure a maximum address count from
1-1024 for the port to allow access.
If a port is disabled (shut down) due to a security violation, it must be
u
manually re-enabled from the Interface > Port > General page
(page 139).
P
ARAMETERS
These parameters are displayed in the web interface:
Port – Port number.
u
Action – Indicates the action to be taken when a port security violation
u
is detected:
None: No action should be taken. (This is the default.)
n
Trap: Send an SNMP trap message.
n
Shutdown: Disable the port.
n
Trap and Shutdown: Send an SNMP trap message and disable the
n
port.
Security Status – Enables or disables port security on the port.
u
(Default: Disabled)
Max MAC Count – The maximum number of MAC addresses that can
u
be learned on a port. (Range: 0-1024, where 0 means disabled)
The maximum address count is effective when port security is enabled
or disabled, but can only be set when Security Status is disabled.
W I
EB NTERFACE
To configure port security:
1. Click Security, Port Security.
2. Set the action to take when an invalid address is detected on a port,
mark the check box in the Security Status column to enable security for
a port, and set the maximum number of MAC addresses allowed on a
port.
3.
Click Apply
– 345 –
C 14 | Security Measures
HAPTER
Configuring Port Security