Digisol DG-GS4826S Management Manual page 600

C 22 | Multicast Routing
HAPTER
Configuring Global Settings for Multicast Routing
Show Details
Group Address – IP group address for a multicast service.
u
Source Address – Subnetwork containing the IP multicast source.
u
Source Mask – Network mask for the IP multicast source.
u
Upstream Neighbor – The multicast router (RPF Neighbor)
u
immediately upstream for this group.
Upstream Interface – Interface leading to the upstream neighbor.
u
Up Time – Time since this entry was created.
u
Owner – The associated multicast protocol (PIM-DM, PIM-SM, IGMP
u
Proxy).
Flags – The flags associated with each routing entry indicate:
u
Dense – PIM Dense mode in use.
n
Sparse – PIM Sparse mode in use.
n
Connected – This route is directly connected to the source.
n
Pruned – This route has been terminated.
n
Register flag – This device is registering for a multicast source.
n
RPT-bit set – The (S,G) entry is pointing to the Rendezvous Point
n
(RP), which normally indicates a pruned state along the shared tree
for a particular source.
SPT-bit set – Multicast packets have been received from a source
n
on shortest path tree.
Join SPT – The rate of traffic arriving over the shared tree has
n
exceeded the SPT-threshold for this group. If the SPT flag is set for
(*,G) entries, the next (S,G) packet received will cause the router
to join the shortest path tree. If the SPT flag is set for (S,G), the
router immediately joins the shortest path tree.
Downstream Interface List –
Interface – Interface(s) on which multicast subscribers have been
u
recorded.
State – The flags associated with each downstream interface indicate:
u
Forward – Traffic received from the upstream interface is being
n
forwarded to this interface.
Local – Downstream interface has received IGMP report message
n
from host in this subnet.
– 600 –