Digisol DG-GS4826S Management Manual page 385

Remote Power Pair Controlable – Indicates whether the pair
u
selection can be controlled for sourcing power on the given port
associated with the remote system.
Remote Power Classification – This classification is used to tag
u
different terminals on the Power over LAN network according to their
power consumption. Devices such as IP telephones, WLAN access
points and others, will be classified according to their power
requirements.
Port Details – 802.3 Extension Trunk Information
Remote Link Aggregation Capable – Shows if the remote port is not
u
in link aggregation state and/or it does not support link aggregation.
Remote Link Aggregation Status – The current aggregation status
u
of the link.
Remote Link Aggregation Port ID – This object contains the IEEE
u
802.3 aggregated port identifier, aAggPortID (IEEE 802.3-2002,
30.7.2.1.1), derived from the ifNumber of the ifIndex for the port
component associated with the remote system. If the remote port is
not in link aggregation state and/or it does not support link
aggregation, this value should be zero.
Port Details – 802.3 Extension Frame Information
Remote Max Frame Size – An integer value indicating the maximum
u
supported frame size in octets on the port component associated with
the remote system.
W I
EB NTERFACE
To display LLDP information for a remote port:
1. Click Administration, LLDP.
2.
Select Show Remote Device Information from the Step list.
3. Select Port, Port Details, Trunk, or Trunk Details.
Figure 206: Displaying Remote Device Information for LLDP (Port)
– 385 –
C 15 | Basic Administration Protocols
HAPTER
Link Layer Discovery Protocol