Digisol DG-GS4826S Management Manual page 700

C 26 | SNMP Commands
HAPTER
To send an inform to a SNMPv2c host, complete these steps:
1. Enable the SNMP agent
2. Create a view with the required notification messages
3. Create a group that includes the required notify view
4.
Allow the switch to send SNMP traps; i.e., notifications
5.
Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
To send an inform to a SNMPv3 host, complete these steps:
1. Enable the SNMP agent
2. Create a local SNMPv3 user to use in the message exchange
process (page 703).
3. Create a view with the required notification messages
4. Create a group that includes the required notify view
5. Allow the switch to send SNMP traps; i.e., notifications
6.
Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.
The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
u
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 notifications.
If you specify an SNMP Version 3 host, then the community string is
u
interpreted as an SNMP user name. The user name must first be
defined with the snmp-server user
group will be automatically created by the snmp-server host
command using the name of the specified community string, and
default settings for the read, write, and notify view.
E
XAMPLE
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
R C
ELATED OMMANDS
snmp-server enable traps (697)
– 700 –
(page 694).
(page 694).
command. Otherwise, an SNMPv3
(page 704).
(page 702).
(page 697).
(page 704).
(page 702).
(page 697).