Digisol DG-GS4826S Management Manual page 408

C 15 | Basic Administration Protocols
HAPTER
Simple Network Management Protocol
P
ARAMETERS
These parameters are displayed in the web interface:
SNMP Version 1
IP Address – IP address of a new management station to receive
u
notification message (i.e., the targeted recipient).
Version – Specifies whether to send notifications as SNMP v1, v2c, or
u
v3 traps. (Default: v1)
Community String – Specifies a valid community string for the new
u
trap manager entry. (Range: 1-32 characters, case sensitive)
Although you can set this string in the Configure Trap – Add page, we
recommend defining it in the Configure User – Add Community page.
UDP Port – Specifies the UDP port number used by the trap manager.
u
(Default: 162)
SNMP Version 2c
IP Address – IP address of a new management station to receive
u
notification message (i.e., the targeted recipient).
Version – Specifies whether to send notifications as SNMP v1, v2c, or
u
v3 traps.
Notification Type
u
Traps – Notifications are sent as trap messages.
n
Inform – Notifications are sent as inform messages. Note that this
n
option is only available for version 2c and 3 hosts. (Default: traps
are used)
Timeout – The number of seconds to wait for an
n
acknowledgment before resending an inform message.
(Range: 0-2147483647 centiseconds; Default: 1500
centiseconds)
Retry times – The maximum number of times to resend an
n
inform message if the recipient does not acknowledge receipt.
(Range: 0-255; Default: 3)
Community String – Specifies a valid community string for the new
u
trap manager entry. (Range: 1-32 characters, case sensitive)
Although you can set this string in the Configure Trap – Add page, we
recommend defining it in the Configure User – Add Community page.
UDP Port – Specifies the UDP port number used by the trap manager.
u
(Default: 162)
– 408 –