Digisol DG-GS4826S Management Manual page 527

CLI R
EFERENCES
"service dhcp" on page 1096
u
P
ARAMETERS
These parameters are displayed in the web interface:
DHCP Server – Enables or disables the DHCP server on this switch.
u
(Default: Disabled)
W I
EB NTERFACE
To enable the DHCP server:
1. Click IP Service, DHCP, Server.
2. Select Configure Global from the Step list.
3. Mark the Enabled box.
4.
Click Apply.
Figure 322: Enabling the DHCP Server
S E A
ETTING XCLUDED DDRESSES
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add)
page to specify the IP addresses that should not be assigned to clients.
CLI R
EFERENCES
"ip dhcp excluded-address" on page 1095
u
P
ARAMETERS
These parameters are displayed in the web interface:
Start IP Address – Specifies a single IP address or the first address in
u
a range that the DHCP server should not assign to DHCP clients.
End IP Address – The last address in a range that the DHCP server
u
should not assign to DHCP clients.
Be sure you exclude the address for this switch and other key
N :
OTE
network devices.
– 527 –
C 20 | IP Services
HAPTER
Dynamic Host Configuration Protocol