Digisol DG-GS4826S Management Manual page 660

C 25 | System Management Commands
HAPTER
File Management
You can use "Factory_Default_Config.cfg" as the source to copy from
u
the factory default configuration file, but you cannot use it as the
destination.
To replace the startup configuration, you must use startup-config as
u
the destination.
Use the copy file unit command to copy a local file to another switch in
u
the stack. Use the copy unit file command to copy a file from another
switch in the stack.
The Boot ROM and Loader cannot be uploaded or downloaded from the
u
FTP/TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
For information on specifying an https-certificate, see
u
Default Secure-site Certificate" on page
configuring the switch to use HTTPS for a secure connection, see the
http secure-server command.
When logging into an FTP server, the interface prompts for a user name
u
and password configured on the remote server. Note that "anonymous"
is set as the default user name.
E
XAMPLE
The following example shows how to download new firmware from a TFTP
server:
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: 2
Source file name: m360.bix
Destination file name: m360.bix
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#
The following example shows how to upload the configuration settings to a
file on the TFTP server:
Console#copy file tftp
Choose file type:
1. config: 2. opcode: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
– 660 –
"Replacing the
306. For information on
ip