Digisol DG-GS4826S Management Manual page 219

device with the lowest MAC address will then become the root device.
(Note that lower numeric values indicate higher priority.)
Default: 32768
n
Range: 0-61440, in steps of 4096
n
Options: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672,
n
32768, 36864, 40960, 45056, 49152, 53248, 57344, 61440
BPDU Flooding – Configures the system to flood BPDUs to all other
u
ports on the switch or just to all other ports in the same VLAN when
spanning tree is disabled globally on the switch or disabled on a specific
port.
To VLAN: Floods BPDUs to all other ports within the receiving port's
n
native VLAN (i.e., as determined by port's PVID). This is the default.
To All: Floods BPDUs to all other ports on the switch.
n
The setting has no effect if BPDU flooding is disabled on a port (see
"Configuring Interface Settings for
Advanced Configuration Settings
The following attributes are based on RSTP, but also apply to STP since the
switch uses a backwards-compatible subset of RSTP to implement STP, and
also apply to MSTP which is based on RSTP according to the standard:
Path Cost Method – The path cost is used to determine the best path
u
between devices. The path cost method is used to determine the range
of values that can be assigned to each interface.
Long: Specifies 32-bit based values that range from 1-200,000,000.
n
(This is the default.)
Short: Specifies 16-bit based values that range from 1-65535.
n
Transmission Limit – The maximum transmission rate for BPDUs is
u
specified by setting the minimum interval between the transmission of
consecutive protocol messages. (Range: 1-10; Default: 3)
When the Switch Becomes Root
Hello Time – Interval (in seconds) at which the root device transmits a
u
configuration message.
Default: 2
n
Minimum: 1
n
Maximum: The lower of 10 or [(Max. Message Age / 2) -1]
n
Maximum Age – The maximum time (in seconds) a device can wait
u
without receiving a configuration message before attempting to
reconfigure. All device ports (except for designated ports) should
receive configuration messages at regular intervals. Any port that ages
out STA information (provided in the last configuration message)
– 219 –
C 8 | Spanning Tree Algorithm
HAPTER
Configuring Global Settings for STA
STA").