Digisol DG-GS4826S Management Manual page 665

Table 46: Line Commands (Continued)
Command
password-thresh
silent-time
*
speed *
stopbits *
timeout login response
disconnect
show line
* These commands only apply to the serial port.
line
This command identifies a specific line for configuration, and to process
subsequent line configuration commands.
S
YNTAX
line {console | vty}
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
D S
EFAULT ETTING
There is no default line.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Telnet is considered a virtual terminal connection and will be shown as
"VTY" in screen displays such as
communication parameters (e.g., databits) do not affect Telnet
connections.
E
XAMPLE
To enter console line mode, enter the following command:
Console(config)#line console
Console(config-line)#
R C
ELATED OMMANDS
show line (673)
show users (654)
C 25 | System Management Commands
HAPTER
Function
Sets the password intrusion threshold, which limits the
number of failed logon attempts
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
thresh command
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Sets the interval that the system waits for a login
attempt
Terminates a line connection
Displays a terminal line's parameters
show users. However, the serial
– 665 –
Line
Mode
LC
LC
password-
LC
LC
LC
PE
NE, PE