Digisol DG-GS4826S Management Manual page 1034

C 42 | Multicast Filtering Commands
HAPTER
Multicast VLAN Registration
show mvr
E
XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/7
Console(config-if)#mvr type receiver
Console(config-if)#mvr vlan 3 group 225.0.0.5
Console(config-if)#
This command shows information about the global MVR configuration
settings when entered without any keywords, the interfaces attached to
the MVR VLAN using the interface keyword, or the multicast groups
assigned to the MVR VLAN using the members keyword.
S
YNTAX
show mvr [interface [interface] | members [ip-address]]
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26/50)
port-channel channel-id (Range: 1-32)
ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
D S
EFAULT ETTING
Displays global configuration settings for MVR when no keywords are used.
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
Enter this command without any keywords to display the global settings for
MVR. Use the interface keyword to display information about interfaces
attached to the MVR VLAN. Or use the members keyword to display
information about multicast groups assigned to the MVR VLAN.
E
XAMPLE
The following shows the global MVR settings:
Console#show mvr
MVR Config Status
MVR Running Status
MVR Multicast VLAN
MVR Current Groups
MVR Max. Supported Groups : 255
MVR Upstream Source IP
Console#
– 1034 –
: Enabled
: Active
: 1
: 10
: 192.168.0.3