Figure 41: Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Show Member from the Action List.
4.
Select a Trunk.
Figure 42: Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step List.
3.
Select Configure from the Action List.
4.
Modify the required interface settings. (See
on page 139
for a description of the interface settings.)
5.
Click Apply.
– 159 –
C
5
| Interface Configuration
HAPTER
Trunk Configuration
"Configuring by Port List"