Digisol DG-GS4826S Management Manual page 865

E
XAMPLE
The following example creates trunk 1 and then adds port 11:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP)
for the current interface. Use the no form to disable it.
S
YNTAX
[no] lacp
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
The ports on both ends of an LACP trunk must be configured for full
u
duplex, either by forced mode or auto-negotiation.
A trunk formed with another switch using LACP will automatically be
u
assigned the next available port-channel ID.
If the target switch has also enabled LACP on the connected ports, the
u
trunk will be activated automatically.
If more than eight ports attached to the same target switch have LACP
u
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
E
XAMPLE
The following shows LACP enabled on ports 10-12. Because LACP has also
been enabled on the ports at the other end of the links, the
status port-channel 1
Console(config)#interface ethernet 1/10
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic Information:
Port Type
C 33
HAPTER
command shows that Trunk1 has been established.
: 1000T
– 865 –
| Link Aggregation Commands
show interfaces