Digisol DG-GS4826S Management Manual page 251

C U
OMMAND SAGE
This mapping table is only used if the protocol type of the arriving
u
packet is TCP or UDP. Some of the more common TCP service ports
include: HTTP: 80, FTP: 21, Telnet: 23 and POP3: 110.
No default mapping is defined for ingress TCP/UDP port types.
u
IP Port settings apply to all interfaces.
N :
OTE
P
ARAMETERS
These parameters are displayed in the web interface:
IP Port Mapping Status – Enables or disables the use of TCP/UDP
u
destination port numbers priorities and the mapping of these priority
values to CoS values. (Default: Disabled)
TCP/UDP Port – 16-bit TCP/UDP destination port number.
u
(Range: 0-65535)
CoS – Class-of-Service value (Range: 0-7)
u
W I
EB NTERFACE
To set the TCP/UDP port number to CoS priority map:
1. Click Traffic, Priority, IP Port to CoS.
2. Select Add from the Action list.
3.
Set the CoS priority for any TCP or UDP port.
4. Click Apply.
Figure 115: Mapping IP Port Number Priority Values
– 251 –
C 11 | Class of Service
HAPTER
Layer 3/4 Priority Settings