Digisol DG-GS4826S Management Manual page 177

untagged they are not connected to any VLAN-aware devices. Or configure
a port as forbidden to prevent the switch from automatically adding it to a
VLAN via the GVRP protocol.
CLI R
EFERENCES
"Configuring VLAN Interfaces" on page 932
u
"Displaying VLAN Information" on page 939
u
P
ARAMETERS
These parameters are displayed in the web interface:
Edit Member by VLAN
VLAN – ID of configured VLAN (1-4093).
u
Interface – Displays a list of ports or trunks.
u
Port – Port Identifier. (Range: 1-26/50)
u
Trunk – Trunk Identifier. (Range: 1-32)
u
Mode – Indicates VLAN membership mode for an interface.
u
(Default: Hybrid)
Hybrid – Specifies a hybrid VLAN interface. The port may transmit
n
tagged or untagged frames.
1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A
n
trunk is a direct link between two switches, so the port transmits
tagged frames that identify the source VLAN. Note that frames
belonging to the port's default VLAN (i.e., associated with the PVID)
are also transmitted as tagged frames.
PVID – VLAN ID assigned to untagged frames received on the interface.
u
(Default: 1)
If an interface is not a member of VLAN 1 and you assign its PVID to
this VLAN, the interface will automatically be added to VLAN 1 as an
untagged member. For all other VLANs, the PVID must be defined first,
then the status of the VLAN can be configured as a tagged or untagged
member.
Acceptable Frame Type – Sets the interface to accept all frame
u
types, including tagged or untagged frames, or only tagged frames.
When set to receive all frame types, any received frames that are
untagged are assigned to the default VLAN. (Options: All, Tagged;
Default: All)
Ingress Filtering – Determines how to process frames tagged for
u
VLANs for which the ingress port is not a member. (Default: Disabled)
Ingress filtering only affects tagged frames.
n
– 177 –
C 6 | VLAN Configuration
HAPTER
IEEE 802.1Q VLANs