Digisol DG-GS4826S Management Manual page 154

C 5 | Interface Configuration
HAPTER
Trunk Configuration
5. Set the unit and port for the initial trunk member.
6. Click Apply.
Figure 34: Creating Static Trunks
To add member ports to a static trunk:
1. Click Interface, Trunk, Static.
2. Select Configure Trunk from the Step list.
3. Select Add Member from the Action list.
4.
Select a trunk identifier.
5. Set the unit and port for an additional trunk member.
6. Click Apply.
Figure 35: Adding Static Trunks Members
To configure connection parameters for a static trunk:
1. Click Interface, Trunk, Static.
2. Select Configure General from the Step list.
3. Select Configure from the Action list.
4.
Modify the required interface settings. (Refer to
List" on page 139 for a description of the parameters.)
5. Click Apply.
– 154 –
"Configuring by Port