Digisol DG-GS4826S Management Manual page 81

M C
ANUAL ONFIGURATION
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and
management stations that exist on another network segment. Valid IPv4
addresses consist of four decimal numbers, 0 to 255, separated by periods.
Anything outside this format will not be accepted by the CLI program.
An IPv4 address for this switch is obtained via DHCP by default.
N :
OTE
A IP 4 A
SSIGNING AN V DDRESS
Before you can assign an IP address to the switch, you must obtain the
following information from your network administrator:
IP address for the switch
u
Network mask for this network
u
Default gateway for the network
u
To assign an IPv4 address to the switch, complete the following steps
1. From the Global Configuration mode prompt, type "interface vlan 1" to
access the interface-configuration mode. Press <Enter>.
2. Type "ip address ip-address netmask," where "ip-address" is the switch
IP address and "netmask" is the network mask for the network. Press
<Enter>.
3. Type "exit" to return to the global configuration mode prompt. Press
<Enter>.
4. To set the IP address of the default gateway for the network to which
the switch belongs, type "ip default-gateway gateway," where
"gateway" is the IP address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
A IP 6 A
SSIGNING AN V DDRESS
This section describes how to configure a "link local" address for
connectivity within the local subnet only, and also how to configure a
"global unicast" address, including a network prefix for use on a multi-
segment network and the host portion of the address.
An IPv6 prefix or address must be formatted according to RFC 2373 "IPv6
Addressing Architecture," using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used to indicate the appropriate number
of zeros required to fill the undefined fields. For detailed information on the
– 81 –
C 2 | Initial Switch Configuration
HAPTER
Basic Configuration