Digisol DG-GS4826S Management Manual page 988

C 41 | Quality of Service Commands
HAPTER
The committed-rate cannot exceed the configured interface speed, and
u
the committed-burst cannot exceed 16 Mbytes.
Policing is based on a token bucket, where bucket depth (i.e., the
u
maximum burst before the bucket overflows) is by specified the
committed-burst field, and the average rate tokens are added to the
bucket is by specified by the committed-rate option. Note that the
token bucket functions similar to that described in RFC 2697 and RFC
2698.
The behavior of the meter is specified in terms of one token bucket (C),
u
the rate at which the tokens are incremented (CIR – Committed
Information Rate), and the maximum size of the token bucket (BC –
Committed Burst Size).
The token bucket C is initially full, that is, the token count Tc(0) = BC.
Thereafter, the token count Tc is updated CIR times per second as
follows:
If Tc is less than BC, Tc is incremented by one, else
n
Tc is not incremented.
n
When a packet of size B bytes arrives at time t, the following happens:
If Tc(t)-B  0, the packet is green and Tc is decremented by B down
n
to the minimum value of 0, else
else the packet is red and Tc is not decremented.
n
E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the
the service that incoming packets will receive, and then uses the police
flow command to limit the average bandwidth to 100,000 Kbps, the burst
rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police flow 100000 4000 violate-action drop
Console(config-pmap-c)#
– 988 –
class command to
set command to classify