Setting The Time Manually - Digisol DG-GS4826S Management Manual

C 4 | Basic Management Tasks
HAPTER
Setting the System Clock
S T
ETTING THE IME
M
ANUALLY
Use the System > Time (Configure General - Manual) page to set the
system time on the switch manually without using SNTP.
CLI R
EFERENCES
"calendar set" on page 688
u
"show calendar" on page 689
u
P
ARAMETERS
The following parameters are displayed in the web interface:
Current Time – Shows the current time set on the switch.
u
Hours – Sets the hour. (Range: 0-23; Default: 0)
u
Minutes – Sets the minute value. (Range: 0-59; Default: 0)
u
Seconds – Sets the second value. (Range: 0-59; Default: 0)
u
Month – Sets the month. (Range: 1-12; Default: 1)
u
Day – Sets the day of the month. (Range: 1-31; Default: 1)
u
Year – Sets the year. (Range: 2001-2100; Default: 2009)
u
W I
EB NTERFACE
To manually set the system clock:
1. Click System, then Time.
2. Select Configure General from the Action list.
3.
Select Manual from the Maintain Type list.
4.
Enter the time and date in the appropriate fields.
5. Click Apply
Figure 11: Manually Setting the System Clock
– 124 –