Digisol DG-GS4826S Management Manual page 885

auto-traffic-control
alarm-clear-
threshold
This command sets the lower threshold for ingress traffic beneath which a
cleared storm control trap is sent. Use the no form to restore the default
setting.
S
YNTAX
auto-traffic-control {broadcast | multicast}
alarm-clear-threshold threshold
no auto-traffic-control {broadcast | multicast}
alarm-clear-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The lower threshold for ingress traffic beneath which a
cleared storm control trap is sent. (Range: 1-255 kilo-packets per
second seconds)
D S
EFAULT ETTING
128 kilo-packets per seconds
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
Once the traffic rate falls beneath the lower threshold, a trap message
u
may be sent if configured by the
broadcast-alarm-clear
multicast-alarm-clear
If rate limiting has been configured as a control response, it will
u
discontinued after the traffic rate has fallen beneath the lower
threshold, and the release timer has expired. Note that if a port has
been shut down by a control response, it will not be re-enabled by
automatic traffic control. It can only be manually re-enabled using the
auto-traffic-control control-release
E
XAMPLE
This example sets the clear threshold for automatic storm control for
broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast alarm-clear-threshold 155
Console(config-if)#
– 885 –
C 36 | Automatic Traffic Control Commands
HAPTER
snmp-server enable port-traps atc
command or snmp-server enable port-traps atc
command.
command.